Roofing Ventilation Products

TSB150 ™ ROOF VENT

(PATENT PENDING)

(TRADEMARK PENDING)

DESIGN FEATURES: Constructed of durable, rust free polypropylene. Fully baffled to protect against rodents, insects, and birds. Large flashing base/flange for ease of installation

· Breakthrough product combines exceptional net free area, ease of installation, good looks and durability

· 150* square inches of net free area = 8.3’ of Ridge Vent = more NFA than other round vents = Good alternative to ridge vent

· TDI (Texas Department of Insurance) approved product evaluation RV-36

· More NFA = Fewer Vents Required and fewer holes in roof

· Low Profile

· Will not rust

· Flat base nails down easily

· Much greater longevity/life span than rusting metal vent options=much cheaper long term

· Durable, Damage resistant = Less Waste (able to withstand full size adult jumping on the dome without permanent damage)

· Hail resistant

· 5 year UV inhibitor package

· 4 screws ensure dome stays attached during high winds

· Use on any pitch up to 16/12, minimum pitch 4/12 (not for flat roofs)

· Water diverters built into base

· 2 Year Warranty is Double the Industry Average

· In a nutshell the TSB150 is better/cheaper/faster/easier than the competition

· Look for the Tamlyn TSB-150 name built into the base for authenticity

· AC Contractors-tired of working in hot attics with poor ventilation install Tamlyn TSB150 and other ventilation products (make sure there is goof intake /soffit ventilation also)

EASIER INSTALLATION

· Lighter weight

· Larger flashing base, easier nailing

· No sharp edges

AVAILABLE COLORS: Weatherwood, Black, and Brown

SAMPLE SPECIFICATION: Tamlyn TSB150 Weatherwood

*Rounded, actual NFA 152.96867

The next best thing to ridge vent!™

Vent Picture Options: You Make The Call

Don’t let one product mar the look of your entire home or apartment

Lower profile is more attractive

Named “Hot Product” by LBM Journal

New Hail Test Video

MOFLO® RIDGE VENT

US Patent #6,277,024

US Trademark #3,134,018

DESIGN FEATURES: Moflo® Ridge vent is a sectional, shingle over ridge vent specially designed to extract heat and moisture out of the attic. For the ultimate protection from heat and moisture, offers the maximum ventilation - 18 square inches of net free area per linear foot. External baffles and internal "sine-wave" shaped baffles prevent wind-driven rain and snow infiltration. Moflo® Ridge Vent features embossed nail lines for correct nail placement and an embossed center line for proper alignment on the ridge. Each section also contains integrated end plugs located every foot to reduce scrap

COMPOSITION & MATERIAL: Injection-molded polypropylene modified for impact resistance and UV resistance

CODES: Moflo® Ridge Vent when installed properly, complies with nationally recognized building codes including Dade County # 01-0626.08 Texas Dept. of Insurance #RV-28, BOCA, ICC, SBCCI, ICBO, FHA and HUD

NOTE: Must be used with an equal or greater amount of soffit ventilation per linear foot. Installs on pitches 3/12 to 16/12. Use with standard 12" wide cap shingles. Use 2-1/2" nails to assure penetration into the sheathing 3/4" or completely through the sheathing

SAMPLE SPECIFICATION: Tamlyn Moflo® Ridge Vent