|
Anchors & Clips |
|
FRAMING ANCHORS DESIGN FEATURES: FA3 anchors have been designed especially for use on 2 x 4, 2 x 3 and 3 x 4 framing MATERIAL: 18 ga. galvanized steel LOADS: (shown with directional arrow) are normal with 25% increase for maximum, and are based on laboratory tests SPECIAL: the FAL anchor provides a plate to transfer the shear force to the blocking connection or rim joist from the top plate. The improved nail pattern helps prevent splitting of the wood members for both single/double top plate situations * Some products available in G-185 Triple Zinc or Hot-Dip Galvanized. Call for availability |
|
MULTI-PURPOSE FRAMING ANCHORS DESIGN FEATURES: AP45 anchors provide the builder with the industry's most versatile framing anchor including: Bending slots - make accurate bends for all 2 and 3-way anchoring ties on the job. MATERIAL: 18 ga. galvanized steel * Some products available in G-185 Triple Zinc or Hot-Dip Galvanized. Call for availability. |
|
CLIP ANCHORS / SKEWED DESIGN FEATURES: versatile reinforcing angles for a multi-purpose anchor around the job. These are generically known as TECO™ clips. They can be nailed to concrete slabs to hold posts or studs, or for high uplift conditions. Holes are staggered to eliminate wood splitting and to permit installation on both sides of the timber. The CAS is a clip anchor that can be field skewable from 0° to 135°. MATERIAL: 18 ga. galvanized steel |
|
TRUSS CLIPS DESIGN FEATURES: permit easy, fast tying of trusses to non-load-bearing walls. Vertical slotted hole allows vertical movement of quick and simple truss seating under a full, dead load condition. MATERIAL: 18 ga. galvanized steel INSTALLATION: TC - 2 nails to plate, 1 into slot. TCL - 2 nails to plate, 1 into slot. TCD - 4 nails to plate, 2 into slot. TCL is used when a longer leg is needed to reach a truss or rafter because of separation from a non-bearing top plate. Lower truss chord can be attached to either side of the upstanding leg. Nails must be installed at the middle of the slot. TCH - has a 2-1/2" slot to accommodate the movement of commercial trusses for high lateral capacity. |
|
Tamlyn Partners Premium Products for Professionals |
|
© Copyright 2008 |
